Page 1 of 1

One Robot Spider Leg with issues...

Posted: Thu Oct 12, 2017 7:52 am
by Destiny
Hi.. I do not get this. If I add the top of the next part and Link to the last part of the leg joint, it will not Simulate.. It should just connect and drag it with the leg.. What do you think I am doing wrong.. ??? Currently its missing two Links... I tried to animate the entire spider but because this Link will not work, nothing works..

Destiny...

Re: One Robot Spider Leg with issues...

Posted: Thu Oct 12, 2017 10:34 am
by Destiny
Perhaps its a fact that its impossible as its made.. I left out the small bar on this attached. The top bar Simulates now but not with the small bar added.. With this part not working means I cannot Simulate the Spider Robot, due to errors in the design.. Again, this provides real value in Simulation.. The design needs tinkering with.... Perhaps one end of the bar needs a slot rather than a hole.. Not sure..

Just another model to give up on. :lol: :lol:

Destiny..

Re: One Robot Spider Leg with issues...

Posted: Thu Oct 12, 2017 10:43 am
by Destiny
This shows it can actually animate. So, why can't Simlab Composer do it.. emmmm What am I doing wrong...??? :? :? :?

https://grabcad.com/library/spider-robot-6

Destiny..

Re: One Robot Spider Leg with issues...

Posted: Thu Oct 12, 2017 11:00 pm
by Destiny
YAY!.. I got it working.. Open and Play the Animation.. It just needed a bit more tinkering with.. :D :D :lol:

I will now animate the Spider Robot.. ;)

Destiny...