Command Line Error: SimLab Composer is closing, ...

Post Reply
billatarcat
Posts: 1
Joined: Thu Oct 22, 2020 6:45 pm

Command Line Error: SimLab Composer is closing, ...

Post by billatarcat » Thu Oct 22, 2020 7:13 pm

Hi All,

I am using the composer on the command line to convert a DWF to a SKP using this command:
c:\ bla bla bla\SimLabComposer.exe -ie c:\ bla bla bla\some_file.dwf c:\ bla bla\some_file.skp
and I get the following message:
SimLab Composer is closing, this may be due to one of the following: not enough memory, end of trial license, or and interal error. Report the issue to ....
I have paid for the tool and it does work, in the same fashion via DynamoSandbox.
Does anyone know what I am doing wrong?

Thank you all for the hand,
Bill :D

PS - is there a PDF or -help that can show me all that can be done via the command line? Thx again.

User avatar
SimLab
Posts: 3222
Joined: Mon Jan 04, 2010 8:09 am

Re: Command Line Error: SimLab Composer is closing, ...

Post by SimLab » Fri Oct 23, 2020 7:36 pm

You are using SimLab Composer ultimate?

Can you share the file with support@simlab-soft.

They can check it for you.

Post Reply